How to save money on mining? Two S9 in 1 S11 -1500w

– Do you have an S9? – Is the complexity increasing? – Consumption is not good either?

Step-by-step instructions on how to reduce power consumption with multiple S9 asics. And so, let’s get started! Essentially, we take 2 S9 13.5T – flash 1 control board for 6 pins and voila! We get 1 S11 for 20T with a consumption of 1550W As we know, Antminer is called S9, because it is possible to connect up to 9 hash boards with the appropriate connectors. Our craftsmen solder 3 pcs. to the control board additionally and install the firmware on the Downvolt so that each of the nodes works in a gentle mode (±10W), which gives us a total of 20W from two nodes – 1550W consumption and the ability to operate each node with only one cooler, which will significantly reduce noise from one device. CONCLUSION : 1) The asic will serve us much longer, due to the fact that we did not overclock, but downvoltage the firmware, and the chips are less subject to wear 2. Consumption is reduced by 2 times! 3. Tx has dropped to the level of t9+, but in total there is an increase due to consumption. How much does this service cost? Check with a consultant at any of our numbers: – 068 011-39-42 – 073 322-29-30 Since you won’t need a second control board after the Up-grade, we can take it away from you, making this service absolutely free! AsicFox Service is always with you! – We give a 30-day warranty – We repair hash boards / control boards / change foams / carry out complex cleaning – We do hardware and software diagnostics – for FREE